User

the module SN:001A07286792 Evo-all

2014 Mazda CX5 ; manual push to start ; Evo-one w/MAZ THAR ; SN 002b04 638289

Cranks but doesn't start. All fob functions work, car runs normally, and it goes into ready mode and shuts down after exiting. Won't autostart after getting out of the vehicle - what am I missing? Valet mode off.

Using default settings with the plug&play harness.

Firmware 85.14

A1 through A-10 : ON

A11 OFF ; B1 OFF ; C1 ON

D2 ON

D3-D5 : OFF ; D6 ON

Firmware 1.26

2 through 15 : option 1 (default)

16.5 ; 18.1 ; 19.1 ; 20.8 ; 21.2 ; 24.1 ; 25 (off) ; 26.1 ; 29.1 ; 30.1 ; 31.1 ; 32.1 ; 33.2 ; 34.1 ; 35.1 36.3 ; 37.1 ; 38.1 ; 39.1

After installing the Lock x3 remote starter and I checked work well. also I flashed the engine to turn off after 15 minutes. But there are situations where the engine turns off when I open the driver's door after starting the remote start. Even though it hasn't been 15 minutes.

It's happens sometimes. What's the problem?

I installed the evo start LTE on a 2000 mustang gt convertible following the installation PDF and have not had any luck getting the evo one module to control any functions on the vehicle. It makes it through and the key setup completes successfully the red light on the unit flashes 10 times. I try to get it to start using the OEM key fob by pressing lock three times and nothing( i don't even hear any clicks or see any lights illuminate on the evo one unit). I have installed fortin units before but it was the evo-all on a 2013 nissan maxima. I remember on that install that once i selected lock from the OEM remote three times the Evo ALL unit would click a couple times and There would be a couple of lights that illuminated on the unit and it started the vehicle at that point. On the Mustang install It does not click or display any lights when you try the three lock commands from OEM remote or even any commands from the evo start app. I was not able to find the disarm - wire(Dark Green/Purple) to connect the disarm - wire on the Evo-One. I have access to wiring diagrams of the Mustang from Identifix technician site and the diagram states this wire on 1999 models only. From what i have found researching this that from 2000 models and on the only antitheft device is the PATS transponder around the ignition barrel. I believe that the disarm wire - from the Evo One unit is there just to disarm any factory alarm if the vehicle has one so im not quite sure if this is the root cause of the evo one not starting the vehicle but don't believe it is. One other area of concern is from the evo start app. The app is connected and paired and i get data back from the car such as voltage, temp, etc, but the app shows the doors on car in red and disarm icon shows in red as well. I can select lock or unlock, open trunk from app and from but nothing happens at the vehicle. Same with selecting engine start from the app. Im attaching a screenshot of wiring diagram mentioned stating 1999 models only along with screenshot of the app. I'm at my wits end with this unit and install and getting close to pulling this unit out of the vehicle completely. So any guidance, help, or suggestions would be greatly appreciated.  https://drive.google.com/file/d/1KOBpTzM-EYKxnvhPk39h_6oibZHVRaAn/view?usp=drive_link

https://drive.google.com/file/d/1jmB7GIgU6ydqwhSFGMQuBKuxq8P5bPyH/view?usp=drive_link

Hello

We have problems installing EVO-NIST1 on a Nissan GTR 2015 and we have followed what fortin said on the instructions and it dont work and also the the instructions fortin has for finding out whats wrong but i dont work as it should !

Between this 2 instructions there is different diagrams with the 2 instructions and that do not make it easier and when plugging in the box should the button be push down or not ?

When programing folloving the lights and the instructions the lights jumps over steps !?

What flash should be used standalone or the other one !?

when pushing the button 3 times only lights but no engine start it never even try to start !?

When disconecting the box every thing works normal.

EVO-ALL number SN: 001A07 535353

Can any one help us in any way to sort this out !